![]() ![]() Optional: Again, you can use nail glue here as well if you wish.įill any nail holes with spackling or wood putty and paint or stain the frame. Using the nail gun, nail the lattice molding against the 1″ x 2″ frame making sure the molding is flush against the outside edges of the 1″ x 2″. ![]() Lay all the pieces out along the 1″ x 2″ pieces and make sure all fit well – all the lattice molding should be flush against the outside of the 1″ x 2″ frame. Cut two pieces of lattice molding to this measurement at a 45 degree angle. Measure the distance between each piece of vertical lattice molding you just cut from long end to long end. Lay the pieces out along the top of the 1″ x 2″ frame with the long edge of the lattice molding flush against the outside of the 1″ x 2″. These will be two of your vertical pieces on the frame. You can cut these pieces with either the miter or circular saw – they just need to be straight edges. Cut two pieces of 1″ x 2″ to the length of the plywood. We did this by laying the print on top of the plywood, tracing around it with a pencil and then cutting the piece of wood along the traced line with a circular saw. If you haven’t already done so, cut your piece of plywood down to the size of your art print.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |